516
Operating Instructions
Do not immerse the
Multiforce Pro™ in
water or any other
liquid.
1. The easiest way to use the machine is to tilt the handle to a 45º angle and
clean slowly 2-3 yards at a time.
2. Hand wash or machine wash the ultra-microfiber pads in the delicate cycle
with a mild detergent.
3. We recommend air drying the ultra-microfiber pads for 24 hours, but they
could be dried in a dryer on a low heat setting.
4. A good amount of steam passes through the ultra-microfiber pads. We
recommend that the ultra-microfiber pads be changed when it
becomes oversaturated.
5. To remove stubborn stains from vinyl or linoleum floors, pre-treat with a mild
detergent and some water before using the floor sanitizer.
Always operate the
Multiforce Pro™ by
gripping the handle.
Do not grip by the
pole.
Care & Maintenance
1. Turn the Multiforce Pro™ off and unplug from
the electrical outlet.
2. Wrap power cord around cord hangers.
3. Let the Multiforce Pro™ cool for five (5) minutes
before removing the ultra-microfiber pads and
before emptying the water tank.
4. Always empty the water tank when you have
finished using the Multiforce Pro™.
5. Never leave ultra-microfiber pads on the
Multiforce Pro™ when you have finished using it.
Always remove the ultra-microfiber pads and
wash in warm water with a mild detergent.
Never use bleach or fabric softener when
cleaning the ultra-microfiber pads.
The ultra-microfiber pads can be washed in a
washing machine and dried in a clothes
dryer but on low heat.
To decrease pad wear, we recommend the
pads be hung to dry for 24 hours.
6. Wipe the Multiforce Pro™ with a damp cloth to
clean. Never immerse the Multiforce Pro™ in water
or any other liquid.
7. In order to keep the Multiforce Pro™ in good
condition, we recommend that you clean the
water tank once a month to eliminate calcium
deposits. Add eight ounces (8 oz) of water to
the water tank and insert 1 packet of Fresh
Rinse™ Lime and Scale Remover. Shake to
loosen any deposits. Place unit on resting
mat without pads, turn unit on and allow water
to steam until water in tank is depleted. Do
not use vinegar or other decalcifying
substances in the floor sanitizer
water tank.
IMPORTANT
Always ensure that the
Multiforce Pro™ is
UNPLUGGED from the
wall receptacle prior to
cleaning or emptying
the water tank.
CAUTION
CAUTION
IMPORTANT: Never leave the Multiforce Pro™ steaming in one spot on any surface for any period of
time.Always place on the floor protector pad and make sure that the floor sanitizer is turned off.
SAVE THESE
INSTRUCTIONS | FOR
HOUSEHOLD USE
Commercial use of this
unit voids the manufac-
turer’s warranty.
Helpful Hints
Q: Can the Multiforce Pro™ be used on laminate flooring?
A: Yes. Your steam mop was designed to be gentle on delicate flooring, yet powerful
enough to penetrate stains and kill harmful germs and bacteria.
It is recommended that the flooring manufacturer be contacted to see if it is OK to
clean the floor with steam. Leaving the steam mop sitting in one spot while steaming
could result in discoloration of flooring.
Q: How long can an Ultra-microfiber Pad be used until it needs to be changed?
A: The pad should be changed every 10 minutes, or when it becomes saturated with
water. The unit will become harder to push with a overly wet pad.
Q: How long does a tank of water last?
A: A full tank will last approximately 20-25 minutes.
Q: Sometimes my floor sanitizer becomes hard to push - why?
A: If the unit is hard to push its likely because the Ultra-microfiber Pad is too wet or
the angle at which you are using the machine is too high.
Q: How do you use the Carpet Glide for my carpet?
A: The carpet glide is to be used without the Ultra-microfiber Pad and can be attached
directly to the unit. DO NOT use CR-motion
™
with the Carpet Glide.
Q: Does the HAAN work on pet stains?
A: Yes, the HAAN is able to spot clean fresh pet stains by loosening and lifting the
stain.
Q: How can I prolong the life of my HAAN?
A: To maintain the life of your unit, we recommend using the Fresh Rinse once a
month.
Q: Will the HAAN Floor Sanitizer clean grout?
A: Yes, but it needs a little help. If you glide your HAAN over the problem areas and
then scrub with your Ultra-microfiber Pad, it should effectively clean your grout.
Commonly Asked Questions
Couldn’t find the Answer to your Question?
Call Customer Care at 877-HAAN DIRECT / 877-422-6347
Comments to this Manuals